COMPANION ScanShell 800 Guide d'installation télécharger pdf (Page 9)

Once scanner maintenance has been enabled select the option to Calibrate ID

Scanner. You will be prompted ﬁrst to insert the calibration card into your scanner.

Do so at this time, noting the alignment directions on the back of the card. Click OK

to begin the calibration process (Image 12). Once calibration has ﬁnished, click OK.!

Image 12!

NOTE: FROM TIME TO TIME THE SCANSHELL 800DX MAY REQUIRE MAINTENANCE OR

CLEANING. USE THESE CONTROLS WHENEVER NECESSARY TO CALIBRATE OR CLEAN

THE SCANNER.!

Once your scanner has been calibrated you may log into the KeepnTrack Kiosk to

perform Sign In using a valid Drivers License. After selecting Sign In, verify the

scanner is ready as indicated by a green colored light on the front of the scanner.

Place an ID in the scanner opening, squarely aligned to the right, and click the SCAN

ID button (Image 13).!

Image 13!

IG0069.3 - V6450 Driver’s License Optical Scanner Page ! of 159

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Pas de commentaire

COMPANION ScanShell 800 Guide d'installation Page 9